Instruction Manual

CALL For Installation ☎︎7003965656

auto pump controller kolkata west bengal

Instruction Manual

Product Installation is Very Easy just Follow the given Instruction below:

1.Unbox the Product & the Instruction Manual.

  1. Get Familiar with the Product. Big BLACK Switch on the left side (For Auto & Manual Operation). On the top of Product there are 6 Sensor wires for Sensor Probe Connection and remaining 3 Wires for Pump Automatic Operation Connection to the pump starter panel.                                                                                                                                                                           Product Installation Procedure:

1.Cut off the power supply for pump starter / switch prior to start the installation.

  1. Hang the Fully Automatic Pump On-Off Controller device near Pump Starter / Switch.
  2. Connect P+ with Phase, Then Pump+ connect with Pump +ve power input supply towards Pump. Then N(-) with Neutral.

FOR OHT TANK SENSOR CONNECTION

Fix the Sensor Probe inside OHT (Over Head Tank) in 3 different Levels, to fix OHT High sensor probe 5 Inches below overflow pipe. OHT Low sensor probe 10 Inches above from bottom and OHT Ground sensor probe just above 8 Inches from tank bottom.

FOR RESERVOIR/UNDERGROUND TANK SENSOR CONNECTION

Fix the Sensor Probe inside Reservoir Tank in 3 Different Levels, To fix RES GROUND sensor probe 4 Inches above suction pipe, RES LOW sensor probe 6 Inches above suction pipe & RES HIGH sensor probe 10 Inches above suction pipe.

CONTROLLER CONNECTION

Bring all 6 sensor wires from OHT &RES Tank (which is connected to the sensor probes as shown in diagram) & connect accordingly. & before starting main switch, be sure AUTO/MANUAL Switch should be in auto position.

(NOTE:- KEEP PUMP STARTER/SWITCH ‘ON’ ALL THE TIME WHEN WATER PUMP CONTROLLER IS IN AUTO POSITION) & MANUAL SWITCH IS FOR EMERGENCY PURPOSE ONLY.

IF YOU FOUND ANY DIFFICULTY DURING INSTALLATION, FEEL FREE TO CONTACT OUR DEALER, DISTRIBUTOR, RESELLER OR COMPANY REPRESENTATIVE.

IMPORTANT NOTE:- It is advised by the company to contact us prior to Installation of Device. Fully Automatic Pump On-Off Controller Installation will vary for different starter panel.

For Installation or Enquiry CALL Today @ 7003965656